Snow-white finishing putty is intended for preparation of concrete, brick, cement-lime and cement-sand bases for finishing inside and outside buildings. With the help of this finishing putty, you can create both a perfectly flat and textured surface of facades and interiors. The snow-white color of the putty allows the paint to reveal itself in a rich, bright, fresh color.

The substrate must be dry, not frozen, strong, capable of bearing loads, free from dust, dirt, oils, greases, old paint residues, wax and other substances that reduce adhesion, have uniform water absorption, and meet the requirements:

DSTU-N B A.3.1-23:2013, DSTU-N B V.2.6-212:2016.

Remove weak areas of the substrate. Potholes, chips, cracks must be repaired, and unevenness leveled using REDBAG TM materials according to their intended purpose. Substrates that have high moisture absorption must be treated with REDBAG ADHESIS deep penetration primer. Attention! Do not apply REDBAG 541 putty to walls with a gypsum base.

Pour the mixture into a container with clean water (at the rate of 7.4-8.0 l of water per 20 kg or 370-400 ml per 1 kg of dry mixture), mix using a construction mixer until a homogeneous mass without lumps is formed. Leave for 5 min. and mix again. Do not add other materials to the prepared putty solution.

The putty solution should be applied using a spatula, trowel, half-trowel or other stainless steel tool to obtain the required thickness. The maximum thickness of the putty layer should not exceed 3 mm per application. Subsequent painting with acrylic, silicate, silicone and other water-based paints can be carried out after 72 hours, and with paints based on organic solvents can be carried out after 7 days after applying the putty.

1.2 kg/m2 at a layer thickness of 1 mm