REDBAG COLOGRIP– ready-to-use vapor-permeable, alkali-resistant, white primer-paint, with the possibility of tinting in pastel colors. It has an excellent covering capacity per square meter of surface. It creates an adhesive layer, and also levels and reduces water absorption of the base for reliable high-quality fixing of subsequent layers of plasters, putties and structural paints. And the special quartz crumb selected and tested in the laboratory contributes to achieving excellent adhesion of the subsequent layer to REDBAG COLOGRIP.

Designed to create a contact-adhesive layer before applying decorative plasters. Improves convenience and facilitates the process of forming the texture of decorative plasters.

Can be used for winter preservation of facades.

The substrate must be dry (residual surface moisture should not exceed 4%), not frozen, strong, capable of bearing loads, free from dust, dirt, oils, greases, lubricants, residues of old paint and meet the requirements of DSTU-N B A.3.1-23:2013 and DSTU-N B V.2.6-212:2016. Remove weak areas of the surface.

The temperature of the air and the substrate to be treated until the primer is completely dry should be within the range of +5°C to +30°C, and the relative humidity should be up to 80%. The temperature of +20 ± 2°C and the relative humidity of 55 ± 5% are the most effective for applying the primer. Under other conditions, the drying time of the primer may change.

The primer REDBAG COLOGRIP is ready to use. It is recommended to mix the primer immediately before carrying out the work, then apply it evenly, without diluting it with water, using a brush or paintbrush to the surface.

The drying time of the primer is 4-6 hours (after drying, the surface should not be sticky). After drying, the applied primer becomes resistant to mechanical stress, and the surface treated with the primer is suitable for applying subsequent layers.

The time interval between the end of the drying of the primer and the start of subsequent work should be as short as possible to avoid the settling of construction dust on the surface of the base.

After carrying out the work, immediately rinse the used tools and containers with water.

from 0.2 to 0.4 kg/m² (depending on the water absorption of the substrate)